This maps them to their MSL equivalents. I've mapped `Coherent` to
`volatile` since MSL doesn't have anything weaker than `volatile` but
stronger than nothing.
As part of this, I had to remove the implicit `volatile` added for
atomic operation casts. If the buffer is already `coherent` or
`volatile`, then we would add a second `volatile`, which would be
redundant. I think this is OK even when the buffer *doesn't* have
`coherent`: `T *` is implicitly convertible to `volatile T *`, but not
vice-versa. It seems to compile OK at any rate. (Note that the
non-`volatile` overloads of the atomic functions documented in the spec
aren't present in the MSL 2.2 stdlib headers.)
`restrict` is tricky, because in MSL, as in C++, it needs to go *after*
the asterisk or ampersand for the pointer type it's modifying.
Another issue is that, in the `Simple`, `GLSL450`, and `Vulkan` memory
models, `Restrict` is the default (i.e. does not need to be specified);
but MSL likely follows the `OpenCL` model where `Aliased` is the
default. We probably need to implicitly set either `Restrict` or
`Aliased` depending on the module's declared memory model.
Avoids ugly warnings on nearly every compute shader.
We could do analysis to detect whether we need to emit this constant,
but it's a bit tedious to figure out if an OpConstantComponent is
actually used by opcodes, so just make it simple.
This is a fairly fundamental change on how IDs are handled.
It serves many purposes:
- Improve performance. We only need to iterate over IDs which are
relevant at any one time.
- Makes sure we iterate through IDs in SPIR-V module declaration order
rather than ID space. IDs don't have to be monotonically increasing,
which was an assumption SPIRV-Cross used to have. It has apparently
never been a problem until now.
- Support LUTs of structs. We do this by interleaving declaration of
constants and struct types in SPIR-V module order.
To support this, the ParsedIR interface needed to change slightly.
Before setting any ID with variant_set<T> we let ParsedIR know
that an ID with a specific type has been added. The surface for change
should be minimal.
ParsedIR will maintain a per-type list of IDs which the cross-compiler
will need to consider for later.
Instead of looping over ir.ids[] (which can be extremely large), we loop
over types now, using:
ir.for_each_typed_id<SPIRVariable>([&](uint32_t id, SPIRVariable &var) {
handle_variable(var);
});
Now we make sure that we're never looking at irrelevant types.