3859f15ec9
When a CMake release introduces a new policy that affects most Qt
modules, it may be appropriate to make each module aware of that newer
CMake version and use the NEW policy without raising the minimum CMake
version requirement. To reduce the churn associated with making that
change across all Qt modules individually, this change allows it to be
updated in a central place (qtbase), but in a way that allows a Qt
module to override it in its own .cmake.conf file if required (e.g. to
address the issues identified by policy warnings at a later time). The
policies are modified at the start of the call to
qt_build_repo_begin().
For commands defined by the qtbase module, qtbase needs to be in
control of the policy settings at the point where those commands are
defined. The above mechanism should not affect the policy settings for
these commands, so the various *Config.cmake.in files must not specify
policy ranges in a way that a Qt module's .cmake.conf file could
influence.
Starting with CMake 3.12, policies can be specified as a version range
with the cmake_minimum_required() and cmake_policy() commands. All
policies introduced in CMake versions up to the upper limit of that
range will be set to NEW. The actual version of CMake being used only
has to be at least the lower limit of the specified version range.
This change uses cmake_minimum_required() rather than cmake_policy()
due to the latter not halting further processing upon failure.
See the following:
https://gitlab.kitware.com/cmake/cmake/-/issues/21557
Task-number: QTBUG-88700
Pick-to: 6.0
Change-Id: I0a1f2611dd629f847a18186394f500d7f52753bc
Reviewed-by: Alexandru Croitor <alexandru.croitor@qt.io>
17 lines
766 B
Plaintext
17 lines
766 B
Plaintext
set(QT_REPO_MODULE_VERSION "6.0.0")
|
|
|
|
# Minimum requirement for building Qt
|
|
set(QT_MIN_SUPPORTED_CMAKE_VERSION "3.18")
|
|
|
|
# Policy settings for commands defined by qtbase. These will also be injected
|
|
# into the top level policy scope of each Qt module when building Qt so that
|
|
# modules have the same policy settings as qtbase by default. They can be
|
|
# overridden by individual Qt modules in their own .cmake.conf files if needed.
|
|
#
|
|
# NOTE: These two values are also hard-coded in QtBuildInternalsConfig.cmake
|
|
# because that file is used in-place by a superbuild, so there is no
|
|
# opportunity for substituting the values from here. Keep both locations
|
|
# in sync.
|
|
set(QT_MIN_NEW_POLICY_CMAKE_VERSION "3.14")
|
|
set(QT_MAX_NEW_POLICY_CMAKE_VERSION "3.19")
|