FIO would keep presenting data after an LZ4F decoding error
resulting in a NULL pointer dereference
when associated with older liblz4 version (< v1.8.1.2)
this makes it possible to specify extremely large negative compression levels,
achieving the side effect as "no compression".
It will also be possible to define larger targetlength for ultra compression mode.
There is no adverse side effect due to removing this limit.
* Replaced a non-breaking space and an en dash with a plain space and
a hyphen.
* This means the files are simple ASCII and less likely to run into
codepage issues.
- do not test level 0, as it is converted into level 3,
which feels strange when compressing multiple levels
- Use direct synchronous mode when a single worker is requested.
access negative compression levels from command line
for both compression and benchmark modes.
also : ensure proper propagation of parameters
through ZSTD_compress_generic() interface.
added relevant cli tests.
zstd bench module can focus on decompression speed _only_.
This is useful when trying to measure performance
on large input data compressed using a high level
as compression time becomes problematic (too long).
This mode is triggered by command : zstd -b -d
Problem was : in such a mode,
measured decoding speed was > 10% slower
than in nominal mode (compression + decompression),
making decompression benchmark mode much less useful.
This patch fixes the issue.
It's not completely clear why, but
moving the `memcpy()` operation sooner in the pipeline fixed it.
I can still measure some difference, but it is in the < 2% range,
so it's much more tolerable.
also : it doesn't matter anymore in which order are selected
commands `-b` and `-d`.
The combination always triggers bench_decodeOnly mode.
Silence a Coverity warning about 'windowSize' being uninitialized.
(Yes, nothing that calls this routine actually uses the windowSize
value. Still, appeasing Coverity is pretty harmless in this case.)
by invoking time() once per batch, instead of once per compression / decompression.
Batch is dynamically resized so that each round lasts approximately 1 second.
Also : increases time accuracy to nanosecond
This makes it easier to explain that nbWorkers=0 --> single-threaded mode,
while nbWorkers=1 --> asynchronous mode (one mode thread on top of the "main" caller thread).
No need for an additional asynchronous mode flag.
nbWorkers>=2 works the same as nbThreads>=2 previously.
added some test
also updated relevant doc
+ fixed a mistake in `lz4` symlink support :
lz4 utility doesn't remove source files by default (like zstd, but unlike gzip).
The symlink must behave the same.
