result of ZSTD_compress_advanced()
is different from ZSTD_compress_generic()
when using negative compression levels
because the disabling of huffman compression is not passed in parameters.
when parameters are "equivalent",
the context is re-used in continue mode,
hence needed workspace size is not recalculated.
This incidentally also evades the size-down check and action.
This patch intercepts the "continue mode"
so that the size-down check and action is actually triggered.
recently introduce into the new dictionary mode.
The bug could be reproduced with this command :
./zstreamtest -v --opaqueapi --no-big-tests -s4092 -t639
error was in function ZSTD_count_2segments() :
the beginning of the 2nd segment corresponds to prefixStart
and not the beginning of the current block (istart == src).
This would result in comparing the wrong byte.
ensure that, when frequency[symbol]==0,
result is (tableLog + 1) bits
with both upper-bit and fractional-bit estimates.
Also : enable BIT_DEBUG in /tests
ZSTD_decompress() can decompress multiple frames sent as a single input.
But the input size must be the exact sum of all compressed frames, no more.
In the case of a mistake on srcSize, being larger than required,
ZSTD_decompress() will try to decompress a new frame after current one, and fail.
As a consequence, it will issue an error code, ERROR(prefix_unknown).
While the error is technically correct
(the decoder could not recognise the header of _next_ frame),
it's confusing, as users will believe that the first header of the first frame is wrong,
which is not the case (it's correct).
It makes it more difficult to understand that the error is in the source size, which is too large.
This patch changes the error code provided in such a scenario.
If (at least) a first frame was successfully decoded,
and then following bytes are garbage values,
the decoder assumes the provided input size is wrong (too large),
and issue the error code ERROR(srcSize_wrong).
distance between levels is slightly increased
to compensate for level 1 speed improvements
and the will to have stronger level 19
extending the range of speed to cover.
reported by @let-def.
It's actually a bug in ZSTD_compressBegin_usingCDict()
which would pass a wrong pledgedSrcSize value (0 instead of ZSTD_CONTENTSIZE_UNKNOWN)
resulting in wrong window size, resulting in downsized seqStore,
resulting in segfault when writing into the seqStore later in the process.
Added a test in fuzzer to cover this use case (fails before the patch).
The new advanced API basically set `requestedParams = appliedParams` when
using a dictionary. This halted all parameter adjustment, which can hurt
compression ratio if, for example, the window log is small for the first
call, but the rest of the files are large.
This patch fixes the bug, and checks that the `requestedParams` don't change
in the new advanced API when using a dictionary, and generally in the fuzzer.
