Speculate that we can modify the SSA value in-place. As long as it is
not used after the modify, this is fine.
Also need to make sure we don't attempt to RMW something that is
impossible to modify.
GLSL and RelaxedPrecision are quite different in what they affect.
RelaxedPrecision affects operations, while this is merely implied in
GLSL based on inputs.
This leads to situations where we have to promote mediump inputs to
highp, and the simplest approach is to force highp temporaries for
inputs which are consumed in a highp context. For completeness, we also
demote RelaxedPrecision inputs to mediump variables.
PHI is handled by copying the PHI into a temporary.
We have to be very careful with hoisted temporaries, since the child
temporary will not be analyzed up-front. We inherit the hoisted-ness
state and emit the hoisted child temporary as necessary. When faking the
temporaries with OpCopyObject, we make sure to block any variable
hoisting.
Hoisting children of PHI variables is fine, since PHIs are not hoisted with
the same framework as other temporaries.
Subsequent stages can legally attempt to read from these variables,
which causes compilation failure.
Always make sure we emit user outputs in vertex shaders if they are
active in the entry point.
This is a fairly fundamental change on how IDs are handled.
It serves many purposes:
- Improve performance. We only need to iterate over IDs which are
relevant at any one time.
- Makes sure we iterate through IDs in SPIR-V module declaration order
rather than ID space. IDs don't have to be monotonically increasing,
which was an assumption SPIRV-Cross used to have. It has apparently
never been a problem until now.
- Support LUTs of structs. We do this by interleaving declaration of
constants and struct types in SPIR-V module order.
To support this, the ParsedIR interface needed to change slightly.
Before setting any ID with variant_set<T> we let ParsedIR know
that an ID with a specific type has been added. The surface for change
should be minimal.
ParsedIR will maintain a per-type list of IDs which the cross-compiler
will need to consider for later.
Instead of looping over ir.ids[] (which can be extremely large), we loop
over types now, using:
ir.for_each_typed_id<SPIRVariable>([&](uint32_t id, SPIRVariable &var) {
handle_variable(var);
});
Now we make sure that we're never looking at irrelevant types.
Previously, when generating non-Vulkan GLSL, each use of a spec constant
would be subsituted for its default value and the declaration of the constant
itself would be omitted completely.
This change slightly alters this behavior. The uses of the constant are kept,
as well as the declaration, although the latter is stripped of the layout
qualifier. The declaration is also prepended with the following code:
#ifndef <constant name>_value
#define <constant name> <default constant value>
#endif
and the constant itself now looks like
const <constant type> <constant name> = <constant name>_value;
The rationale for this change is that it gives the user a way to provide
custom values for specialization constants even when the target does not
support them.
A lot of changes in spirv-opt output.
Some new invalid SPIR-V was found but most of them were not significant
for SPIRV-Cross, so just marked them as invalid.