add rolling/spinning friction to cube, remove it from plane/samurai.urdf
URDF2Bullet: support joint limits for revolute and prismatic, only if defined (if upper < lower, disable limit)
add some profiling markers to improve performance
rolling friction -> only along the normal, until we have separate rolling friction coefficients on normal and non-normal directions
Don't teleport with grasping controller (VR)
Tune VR grasping a bit.
option is disabled by default. When using cmake, use
cmake -DBUILD_PYBULLET=ON -DBUILD_PYBULLET_NUMPY=ON
then both testrender.py and testrender_np.py will work
without numpy only testrender.py works.
The numpy.reshape is likely a no-op when using numpy array,
so we could remove testrender_np.py...
See https://github.com/bulletphysics/bullet3/pull/774
URDF/SDF: add a flag to force concave mesh collisiofor static objects. <collision concave="yes" name="pod_collision">
VR: support teleporting using buttong, allow multiple controllers to be used, fast wireframe rendering,
Turn off warnings about deprecated C routine in btScalar.h/b3Scalar.h
Add a dummy return to stop a warning
Expose defaultContactERP in shared memory api/pybullet.
First start to expose IK in shared memory api/pybullet (not working yet)
returns a pylist of contact points. Each point has the following data:
0 int m_contactFlags;//unused for now
1 int m_bodyUniqueIdA;
2 int m_bodyUniqueIdB;
3 int m_linkIndexA;
4 int m_linkIndexB;
5-6-7 double m_positionOnAInWS[3];//contact point location on object A, in world space coordinates
8-9-10 double m_positionOnBInWS[3];//contact point location on object A, in world space coordinates
11-12-13 double m_contactNormalOnBInWS[3];//the separating contact normal, pointing from object B towards object A
14 double m_contactDistance;//negative number is penetration, positive is distance.
15 double m_normalForce;
Small change that takes the world gravity and applies it to the
body during the call to inverse dynamics in the shared memory
interface. Otherwise the gravity vector is left at the default
value and there is currently no interface to set the gravity
for the inverse dynamics system.
Fix issue in contact/friction between btMultibody and btRigidBody (external force/torque of btRigidBody was not taken into account during contact/friction setup)
Allow 0.1 mm slop in contact, to avoid loosing contact. Todo: allow contacts with positive distance in multibody solver.
Shared memory api/pybullet: by default, set joint motors in position PD mode with target 0, to maintain 0 joint angle.
pybullet: allow setJointControlMode(body, link, POSITION_CONTROL,targetPos etc.
increase from 64 to 128 joints in shared memory API/pybullet
fix potential issue in tinyrenderer, related to missing segmentation mask buffer
report error if CMD_REQUEST_ACTUAL_STATE command on a multibody that exceed the number of links,
todo: stream data to allow arbitrary large number of links in shared memory API
